Take your Flipper's WiFi hacking capabilities to the absolute next level!
A true 3-in-1 module, End Game includes a ESP32-S3 and two optional module slots. Instantly swap between the ESP32-S3 and two modules using the slide switch.
This configuration has a CC1101 module or a NRF24 module.
End Game comes flashed with the manufacturer's personal fork of wifi marauder that includes a few "quality of life" changes.
Some specifics about the End Game device:
Features
- Slide toggle switch to instantly swap between modules (left position - left module, center position - ESP32-S3, right position - right module).
- LED status indicators displaying active module selection.
- ESP32-S3 RGB status indicator (used for attack/sniffing status in wifi marauder - GPIO16).
- ESP32-S3 RX/TX LED indicators.
- ESP32-S3 boot & restart buttons (used for flashing & restart ESP32-S3).
- ESP32-S3 micro-SD card reader (used saving PCAP's of sniffed traffic in wifi marauder).
- ESP32-S3 will come pre-flashed with Wifi Marauder, ready to start sniffing traffic from the get go.. (pssst if you see the RGB rainbow you've sniffed a EAPOL packet, nice!).
- Supports flashing the ESP32-S3 directly from the flipper zero using USB-UART bridge.
- Compatible with the Wifi Marauder companion flipper app, allowing you to control the ESP32-S3 directly from the Flipper Zero.
- External antennas are cross-compatible with modules for general use, optionally you could use more fine tuned antennas for increased performance.
- Compatible with flipper zero silicone cases.
Module pin-out
Row 1 | Row 2 |
---|---|
1: GND | 2: 3V3 |
3: B2 | 4: A4 |
5: B3 | 6: A7 |
7: A6 | 8: N/C |